I made this relaxing bench in my workshop part 2

So now we start in explaining the design and manufacturing process.

The first process I did was to prepare the wood for the legs with measurements;
4cm x 4cm x 60cm = 2 pieces
4cm x 4cm x 78cm = 2 pieces
4cm x 4cm x 45cm = 1 piece
4cm x 4cm x 85cm = 1 piece

The first size is for the left and right front legs and the second size is for the rear legs and the third and fourth sizes are for the front and rear middle legs, because this wood is a former from the construction of a house, of course the sizes are different, so I shaved all the wood and I make the dimensions equal to 4cm x 4cm.

After that I started to line and make holes, as usual I assembled the legs of this bench with a peg hole connection system, this is only for the left and right legs of the bench, while for the middle legs, another method will be used when it is time to assemble them.

Then after the process was complete I started to prepare the wood to assemble the two legs of the bench on the left and right sides using wood measuring 2 cm x 5 cm and for a length of 57 cm, the width of this bench is 60 cm so the way to measure the wood to assemble it is 60 cm minus 8 cm (sum of 2 feet) and added 5cm (pegs for left and right 2.5 cm each) then the result is 57 cm.

And then I assembled it, in this process I used a dowel that I made of 1 cm square wood and drilled it and added glue to make it more sturdy and strong.

After the legs are assembled, then I unite the two legs (left and right) using wood that is the same size but 150cm long (because the length of the bench is 160cm) and the way to measure it is the same as above.

Then in the middle I added wood as a seat for the floor of the bench vertically and horizontally to make it more sturdy, and also I added the front and rear middle legs, for this leg I didn't make holes like the left and right legs, but only carved them according to the thickness of the connecting wood of table leg.

After I assembled the frame of the bench, then I started gluing wood with a thickness of 1 cm and a width of 3 cm using nails on the left and right and front and also wood of this size as the floor and back of this bench,
The distance between each other is 1 cm.

As for the different lengths, for the left and right sides the length is 50cm and for the front side it is 30cm and for the floor is 48cm, of course you ask why the floor size is like that, while the width of the bench is 60cm???

Because for the backrest, I didn't make it straight but slightly tilted about 30 degrees, I did this to make it more comfortable when relaxing.