I do many steps for this project

Hello everyone,, this is post is to show you how i make a bed from my last post,i hope you enjoy it.

So,, now I want to show and explain a little about the process of working on this project...

This bed has a length of 200 cm and a width of 90 cm, suitable for a 3-foot mattress, and for a headrest height of 80 cm and a footrest height of 50 cm.

For the first stage I prepared the wood, the wood I used was "asan" tree, this wood is quite hard wood and has a dense fiber and also has a good pattern, almost similar to "teak" wood, the wood I use is wood that I have already made. store for 2 years and still strong and hard, I cut this wood in my garden and I split it with a thickness of 6 cm.

I shaved the wood using a hand planner machine because I don't have a big planner machine and this drained me a bit, I shaved everything until it had the same thickness of 4.5 cm, then I cut it and I split it with the size:

*4.5 cm x 6.5 cm x 80 cm in 2 parts for the headrest legs.

4.5 cm x 6.5 cm x 50 cm as much as 2 parts for the foot rest.
*3.5 cm x 5.5 cm x 82 cm for connecting the headrest and connecting the footrest for 4 parts.

*4.5 cm x 10 cm x 191 cm in 2 parts for the left and right sides of the bed.

Then I started to make a line on the wood for me to make holes with a drilling machine as a peg hole to string it together with other wood and that was specifically for the legs for the front and rear backrests, while for the wood as the top and bottom base of the backrest I made pegs on the back. each left and right ends and I also make a hole groove with a depth of 1 cm using a router machine as a peg hole for the playwood that I will assemble, in explaining this process I find it difficult to name each part I hope you can understand it with the picture below.

And after that I did everything then I started splitting the playwood with a size of 30 cm x 79 cm for the front and 17 cm x 79 cm for the back, then I started assembling everything and gluing and nailing it.

Then I made a little sponge on the wood for the left and right sides like sponging on the door frame as deep as 2 cm and carved a little under it as a place to hold the mattress floor, and then I started installing the connectors made of iron that I bought at the furniture store I will connect the wood with the front and rear backrest and then I assemble it.

After that I started to make a support on the side of the cot as a barrier so it doesn't fall when my nephew sleeps, and I made this with a dowel system to connect it to the front backrest and screw the bottom with bolts so that it can be removed if it is no longer needed.

After that was all done I started caulking all the wooden surfaces and after drying I sanded them with fine sandpaper so that the results were smooth and lulu I started painting it in 2 layers and waiting for it to dry until the cot can be used.

And that's my explanation for this project, I hope you can understand it, maybe it's not clear, but I hope you can understand it through the pictures I gave, hope you have a nice day and see you in the next post.