You seem to be my kind of crazy, LOL!
These are part of my home health plan:
And:
The top is an interferential stimulator, and the bottom is an ultrasound; for pain control and edema reduction. I picked these units for a very practical reason... I designed both, so I know someone who can work on them, ROFLOL! They helped a lot because I had a car wreck about 6 months ago, and these have controlled most of the pain.
You have to take into consideration the power of the mind, like in vax studies, a placebo can outdo a drug.
The interferentil unit releases endorphins and encephalons ( depending on setting) which are endogenous opiates; which is the source of a 'runner's high'. They are comperable to morphine in strength, and can last 24 hours. Care must be used here, because removing pain in a damaged area can increase the damage, since it doesn't hurt.
The ultrasound is used to increase blood flow by heating and cavitation, which reduces edema and promotes healing. You need to watch for Periosteal pain, caused by heating at the periosteum to bone interface. Lowering the duty cycle will fix this, while maintaining clinical power.
I designed these in the late 1980's, so it was nice to see them still running! They will give me pretty potent Capabilities out on the homestead!
Keep on prepping!!! 👍🤠🙏💗😁
Sounds superb, hope it works out and you get back to rocky fighting fit
👍
I've avoided surgery so far, hope to reduce it to laproscopic instead.
Some kind of pump?
💗😁💙🤠🙏
HHO/Browns gas.
I should have seen that! Are you running it through a bubbler to isolate the generator from the burner, to avoid back flash?
It looks solid and well built. Do you know what Browne gas volume it produces?
💗🤠🙏🤕👍
I was in automotive engineering for 30 years, and grand prix racing before that, I like to make things that maximize their potential :-) Me, you and @rycharde would make a great team for making things.
I'm in, LOL, I have several dozen patents and working on more. The machine shop supports my electronics bench...keeps me busy!
I'll need to follow him, I enjoy live minds!
I didn't recognize your generator, because I've been concentrating on immersed cells, and not sealed ones. Both have advantages, but both are good gas sources! The jar flow rate unit, will let you compare different versions of this generator, with hard numbers.
I still like the heating use!
👍🤕💗🤠
Yes it goes through 2 bubbler's, unsure total output, nothing to measure it with, I just use my eyes and adjust nozzles/jets to suit, and vary it, by November it will be perfected.
If you fill a measured jar with water, then run the hose inside that bottle; the HHO will drive out the water as it is produced. The time it takes to empty the bottle, will give you flow rate.
You can use this to compare production rates for nozzles or other changes.