Motorcycle chain maintenance as well as oil change and tire maintenance are the main conditions for safe biking. For safe travel you need to know how to maintain a motorcycle chain. Chain is the unsung mechanical hero of motorcycles. Important tasks like supplying power to the rear wheels from the engine are done through the chain. Without proper supervision and maintenance it can tear which can cripple the motorcycle.
Depending on how you drive, the chain should be tested every 500-600 km or usually twice a month.
In order to properly maintain the chain of a bike, it needs to be opened and inspected to see what condition it is in.
In order to properly open and maintain the chain, you need a number of tools that should be kept close at hand.
Keep the following things close at hand:
Different types of wrenches
A soft brush or an old toothbrush
A chain cleaner
Rad to clean dirt from chains
A tension pin also known as a cotton pin
. A measuring wire
Let's start the hard work now.
Using the wire gauge, hold the front and rear connecting wheels of the chain well along the middle of the teeth and push it up and down. The chain will move unevenly back and forth like an inch. Because the motorcycle chain may be stiff in some places but it will be normal in other places. So every part of the chain has to be examined thoroughly. If the chain moves more than an inch, it should be tightened and if it is very tight, it should be loosened as required.
The front and rear wheels of the chain can give very good signals about the problem chain. The teeth of the wheel can be examined to see if they are properly attached to the chain. If the teeth look worn out, then understand that they are not in proper condition with the chain. Akabaka teeth are a kind of inconsistency that when you see them you have to understand that it is time to change them.
Your chain must be well-aligned and clean and oiled at the same time. Most modern chains are 0-shaped that use rubber material to make them and such chains are very sensitive. Make sure you are using an approved 0-shape cleaner or use a soft brush to clean chains and chain teeth.
You will then need a rag or towel to remove all the dirt which will create a clean area for oiling. Make sure that the teeth at each junction of the chain and the wheels that hold the chain are clean. When turning the wheel, you can spray oil on the chain. Remove excess oil with a rag.
The extension of the chain is usually determined by the distance between the front and rear sprockets (the teeth of the connecting wheel) and many bikes have index marks to help the element. There are different methods for placing chains on different bikes. Usually rotates through the front and rear extensions of the rear axle and wheel chain.
When the chain is properly stretched, it moves up and down about .75-1 inches. When you turn the rear wheel, make sure that both parts of the chain are tightly fastened before it. If you have not already done so, fasten both the chain and the sprocket. Tighten the axle pins properly and replace the cutter pins with new pins.
After reading this article carefully, I hope you will know how to maintain a motorcycle chain. We look forward to your valuable feedback on this article.