So we've been cut out sheets of 1" Styrofoam, but doing it in two passes was just grinding away at our patience...
EnRoute wouldn't allow us to use just one pass. 😱
Turns out the bit was set to .75" so in order to cut into something over an inch, it would have to make TWO PASSES!!!
Changed to 2 inches, what the bit actually is, and we were back to cutting at a reasonable pace : )
What a nightmare
Neighbor 🥓
This laser
Cuts deep🥓
whoIs
🤬🥓
It's getting messy out there.
Can't release the video because it will ID their assets... 😆